[
Ball Pressure Tester
]
Product Name:
Ball Pressure Tester
Product Model:
JN-QY-2099
Manufacturer:
JENTEST
Product file:
No Related Documents
Product Description
JN-QY-2099 Ball Pressure Tester
The Ball Pressure Test Apparatus is designed to perform tests specified in many standards where resistance of insulating materials to elevated operating temperatures is to be determined.
Ball Pressure Tester
Detail
JN-QY-2099 Ball Pressure Tester
The Ball Pressure Test Apparatus is designed to perform tests specified in many
standards where resistance of insulating materials to elevated operating
temperatures is to be determined.
The device Ball Pressure
Test Apparatus was made according to
IRAM 2073 / IRAM 4220-1 / IEC 61032 / NM 60884-1 IRAM.
The part under test shall be placed on a 3
mm thick plate and in direct contact with the plate.
The surface of the part to be tested is placed in horizontal position and
presses a steel ball of 5mm diameter, against this surface
with a force of 20 N.
The test load and the support must be placed in the oven for a time
sufficient to ensure that the stabilization is reached the test temperature
before testing.
The assay is performed in an oven at a temperature of 125 °C (+/- 2 ° C).
After 1 hour dese must remove the ball from the sample, which is immersed
within 10 seconds in cold water to reach approximately room temperature.
Measure the diameter
of the impression caused by the ball which is not more than 2mm.
Leave a message for product